Yamaha YXR66FW Vehicle PDF Operation Instructions Manual

Front and rear shock absorber adjustment The spring preload can be adjusted to suit the operating conditions. You can reduce preload for a softer ride, or increase preload if frequent bottoming occurs or when carrying loadsAdjust the spring preload as follows: To increase the spring preload, turn the ad- justing ring in direction a. To decrease the spring preload, turn the ad- justing ring in direction b

Trailer hitch bracket and receiver This vehicle is equipped with a trailer hitch bracket and a 5 cm (2 in) receiver for a stan- dard trailer hitch. Trailer towing equipment can be obtained at a Yamaha dealer. (See pages 6-11–6-13 for precaution information.) Auxiliary DC jack The auxiliary DC jack is located at the right side of the front panel. The auxiliary DC jack can be used for suitable work lights, radios, etc. The auxiliary DC jack should only be used when the engine is running

Seat belts This vehicle is equipped with three-point seat belts for both the operator and the passenger. Always wear the seat belts properly while riding in the vehicle. See pages 7-6–7-8 for more information Seats To remove a seat, pull its seat lock lever up- ward, lift the front of the seat, and then slide the seat forward and up

Parking brake lever The parking brake lever is located at the right side of the driver’s seat. It will help keep the vehicle from moving while parked. To set the parking brake, pull the lever up completely. To release the parking brake, pull up on the lever, press the release button, and then push the lever all the way down. Spring pressure helps return the lever to the released position

Accelerator pedal Press the accelerator pedal down to increase engine speed. Spring pressure returns the pedal to the rest position when released. Al- ways check that the accelerator pedal returns normally before starting the engine. This vehicle is equipped with an On-Com- mand four-wheel-drive switch “2WD”/“4WD” and a differential gear lock switch “4WD”/ “LOCK”. Select the appropriate drive accord- ing to terrain and conditions. ? Two-wheel drive (“2WD”): Power is sup- plied to the rear wheels only

Fuel meter The fuel meter indicates the amount of fuel in the fuel tank. The display segments of the fuel meter disappear from “F” (full) towards “E” (empty) as the fuel level decreases. When the “E” segment disappears and the fuel level warning indicator flashes, refuel as soon as possible

Coolant temperature warning light “ ” If the coolant temperature reaches a specified level, this light comes on to warn that the cool- ant temperature is too hot. If the light comes on during operation, stop the engine as soon as it is safe to do so and allow the engine to cool down for about 10 minutes

Reverse indicator light “R” This indicator light comes on when the drive select lever is in the “R” reverse position. Furthermore, this indicator light flashes when the engine is being raced for 10 seconds or more. If the indicator light flashes under any other circumstances or the speedometer does not show the speed while riding, have a Yamaha dealer check the speed sensor circuit.

Download Yamaha YXR66FW Vehicle PDF Operation Instructions Manual