Volvo XC90 Accesories PDF Installation Instructions

INTRODUCTION
• NOTE! Read through the entire text before carrying out any work.
• The front page gives the date of this edition and the edition it replaces
• The second page shows the tools needed for the installation and the contents of the installation kit
• The illustrations display the procedure in order of operation. The order of operation is repeated in the text section
• Cut out the text page in order to follow the illustrations and text at the same time.

Cars equipped with SRS/SIPS (Airbag)
WARNING! Extra care must be taken when working on cars equipped with SRS/SIPS air bags. This is important to prevent:
1. Personal injury
2. Damage to or malfunction of the SRS/SIPS system. Work on the SRS/SIPS systems or related components must always be carried out by an authorised Volvo workshop. Is the car equipped with SRS (supplemental restraint system)? Cars equipped with a driver’s airbag have the letters “SRS” imprinted on the centre panel of the steering wheel. Cars equipped with driver’s and passenger airbags are marked with “SRS” on both the steering wheel centre panel and also on the dashboard close to the airbag. If the car is equipped with SIPS (side impact protection system) a “SIPS” decal is marked on both the front seats.

Cars equipped with inflatable curtains have the marking “SRS” on one of the panels along the posts on the inside of the car. Cars equipped with SRS (supplemental restraint system) also have a “SRS” decal on the front windscreen. Do not damage the SRS wiring! Do not trap, fray, pierce or damage the SRS wiring. SRS wiring has orange casing and/or is plaited. Steering and front suspension The contact reel in the SRS system can easily be damaged when working on the steering wheel, steering shaft or steering gear. Refer to the SRS (supplemental restraint system). Service Manual or service instructions in VIDA for information on carrying out such work. This is to prevent damage. SRS warning lamp. If the SRS warning lamp lights after repairs have been carried out, take the car to an authorised Volvo cars workshop. SRS collision sensor control module Tow hitch wiring, 7/4-pin NOTE! The relay and fuses are not included in the kit.

Installing the tow hitch connector
– Install the tow hitch connector using the four screws and nuts. Tighten

– Route the cable harness to the right along the front edge of the tow hitch member The cable harness is routed the same way regardless of the type of tow hitch

– Secure the cable harness using a tie strap on each side of the brackets for the tow hitch member.
NOTE! If the cable harness is stretched too far it may be worn through by the lower edge of the bumper. Ensure that the cable harness forms a small loop around the lower edge of the bumper as illustrated in illustration B.

Download Volvo XC90 Accesories PDF Installation Instructions