Toyota/Lexus/Scion TOY-SC1 Sirius Connect Interface PDF Installation Manual

The TOY-SC1 is designed to emulate many of the factory SDAR (Satellite Digital Audio Radio) commands found in your vehicle.
• Channel Tune (Up and Down)
• Fast Tune (Up and Down)
• Category Search (Up and Down)
• Category Tune (Tune within a category)
• 12 presets (6 for each band)
• Preset Scan (UP)
Note about features listed: Each Toyota/Lexus/Scion radio type operates differently, so consult the vehicle owners manual for proper operation methods. Headunit Display Capability When the TOY-SC1 is installed, the following information can be displayed on the headunit display

Text Scrolling Configuration
Text Scrolling and/or Paging can be enabled or disabled during installation of the HON-SC1. Enabling scrolling will allow radio types with limited displays to show complete text strings for artist name or song title. Text scrolling should be disabled for radios with large displays where it isn’t needed. The unit is set for text scrolling enabled at the factory. Note: Some Toyota/Lexus headunits will display “XM1” or “XM2” as the display source. This information is hard coded in the headunit design and can not be changed.

Dip Switch Settings
Two dip switches located on the side panel are used to configure the unit for correct display to match your headunit. Labeled 1 and 2 for text scroll and display length settings respectively

1. Set dip switch 1 to Scroll ON/ Scroll OFF as follows:
a) Radios with media or navigation displays: OFF (up position)
b) For radios with smaller text displays set switch 1 to ON (down) if test scrolling is desired.
2. Set dip switch 2 to the up position for the 16 character setting or to the down position for the 11 character position in order to match the display of your specific radio. Note: The default settings from the factory are “scroll off” and “16 character”. In order for text display configuration
switch settings to take effect, you must disconnect power to the TOY-SC1 module then reconnect and turn ignition on again

Installation
Directed Electronics recommends that you have this product professionally installed. It is recommended that prior to starting the installation, you thoroughly read this manual and follow the guidelines listed below: Some installations may use the factory satellite radio tuner location. If you are using this location, please follow the factory instructions for installing the TOY-SC1 in your vehicle. If you are not using this location, please read the following installation guidelines.

Consider the mounting location carefully. You should make sure that you avoid the following:
• Any location where the unit is exposed to moisture.
• Any location where the unit is exposed to extreme heat.
• Any location that would interfere with moving parts on the vehicle or hamper driving.
Mounting the TOY-SC1 Interface: Be sure that you find a location that is flat and has clearance above the unit to prevent any damage as well as allow for ventilation. Do not install the TOY-SC1 under the carpet or in a small enclosed area without proper ventilation. Doing so can result in damage to the tuner or the vehicle…

Activating Your Installed SIRIUS Tuner
For systems using the permanently installed SCC1 Sirius-Connect Vehicle Tuner, you must activate the tuner before you can begin to receive the SIRIUS Satellite Radio Service. In order to activate your radio subscription, you will need the SIRIUS ID (SID) which uniquely identifies your tuner.
The SID can be found on a sticker located on the SCC1 packaging, or on the bottom of the SCC1 itself. When you have located the SID, write it down in the space provided near the end of this manual and store it for future reference.

The SID can also be recalled from your Sirius-Ready Toyota, Lexus or Scion radio. Most units will display the SID on Channel O. Please consult your vehicle owner’s manual or radio user guide for specific details about satellite radio operation. Power on your system and make sure that you are receiving good signal and that you are able to hear audio on the SIRIUS Preview channel (Ch-184).

Download Toyota/Lexus/Scion TOY-SC1 Sirius Connect Interface PDF Installation Manual