Toyota Tundra Stepside PDF Installation Instructions Manual

Read your owner’s manual and these instructions before installing your Toyota Tundra Truxedo kit. side rail clamps Follow these instructions to install your TruXedo and adapter pan. Side rails are notched and pre-bent to conform to your pickup bed.

This seal should be applied BEFORE the side rails are attached. The following pictures are shown with the side rails attached to illustrate the
4”) and place along the area marked by x’s in the photo below. different but placement of the seal is the same.) Position clamps 9” and 36” from front of box; and 8” clamps per side rail). Clamp side rails to pickup
front of bed at locations shown.

Align side rails 1/4” with bed rail and level with each other. Tighten clamp
owner’s manual). Center pan adapter on front header. Fasten 3/8” x
3/4” stove bolts through holes in pan adapter and into square nuts inside header slot. Tighten bolts. Back spring plunger out. Set cover assembly across cab end of side rails. Insert screws in front header through slots in side rails. Secure with plastic washers and lock nuts, but do not over tighten. Header must be free to slide.

Download Toyota Tundra Stepside PDF Installation Instructions Manual