Toyota Tundra Pro Step PDF Installation Instructions Manual

Before you install this kit, read and understand all instructions, warnings, cautions, and notes in this instruction sheet and in the vehicle owner’s manual.
1. Carefully read all warnings and instructions completely before beginning.
2. Verify all parts have been received in this kit by checking the parts list at the end of this document.
3.Only install this kit on the vehicle for which it is specified. If anytime during the installation you encounter something different from what is outlined in the instructions, call technical support at (928) 636-3176.
4. Special tools needed: a. 17/64” drill bit
5. Park vehicle on a clean, dry, flat, level surface and block tires so vehicle cannot roll in either direction.

Engine Compartment
1. Disconnect both battery cables. Disconnect negative cable first, then positive cable.
2. Factory Side Bars
a. Remove factory side bars if present.
b. Install kit side bar (front) onto kit sleeve. Install kit bolt (7/16” x 1”) and kit washer (3/8 USS flat) into kit sleeve.

Install Side Bars on Vehicle
NOTE The side bar can be installed in two positions. It can be installed so that the steps are flat or it can be installed with the steps slightly angled downward.
1. Install steps on vehicle
a. Install the kit side bar assembly (driver) onto kit body brackets using four kit bolts (1/2” X 1-1/4”), four kit washers (1/2” flat), four kit sleeves
(7/8” OD), and four kit nuts (flange). Install the kit bolts into the outer holes in the kit body brackets. DO NOT TIGHTEN.

….

Download Toyota Tundra Pro Step PDF Installation Instructions Manual