Toyota RAV4 2008 Interface Kit For iPod PDF Manual
Please see your Toyota dealer for a copy of the Accessory Installation Practices document.
1. Remove the Negative (–) Battery Cable (Fig. 1-1)
(a) Protect fender before starting.
(b) Place removed vehicle components on protective blanket.
(c) Remove the negative (–) battery cable.
CAUTION: Do not touch the positive terminal with any tool during removal.
2. Vehicle Disassembly
(a) Remove glove box door as follows:
(1) Remove damper arm from glove box door. (Fig. 2-1)
(2) Release glove compartment stoppers by pressing both glove box side panels inward. (Fig. 2-2)
(3) Swing glove box toward you; then remove glove box from two (2) claws and the clip as shown. (Fig. 2-2)
(b) Remove lower glove box trim. (Fig. 2-3)
(1) Disengage the claw and two (2) clips to remove lower glove box trim.
(c) Remove the side trim panels
(1) Apply masking tape to left and right side of dash at trim and radio receiver opening.
(2) Using a nylon pry tool, disengage five
(5) clips on each side and remove the side trim panels. (Fig. 2-4)
(3) Disconnect electrical connectors from each side trim panel.
(d) Remove the head unit
(1) Remove four (4) head unit hex screws, disengage four (4) clips; then pull the head unit toward you to remove. (Fig. 2-5)
(2) Remove the electrical connectors and antenna from rear of head unit. (Fig. 2-6)
Download Toyota RAV4 2008 Interface Kit For iPod PDF Manual
Related Automotive:
- Toyota Avalon 2008 Interface Kit for iPod PDF Manual
- Toyota Tacoma Hypertech Inline Speedometer Calibrator Module PDF Installation Instructions
- Toyota Scion 2004-2007 Front Seat Squeak Noise PDF Manual
- Honda Fit 2009 Accessory HandsFreeLink PDF Installation Instructions Manual
- Ducati 2003 ST4s Timing Belt Adjustment PDF Manual
