Toyota Prius Noise Auxiliary Port External Device PDF Manual

Some customers may notice noise in the auxiliary mode of their audio system when using an MP3 player or other external audio source connected to the 12V power port of the vehicle. An improved auxiliary port and in-line filter has been developed to improve this condition.Use the repair procedure below to install the new in-line filter and auxiliary port.

Repair Procedure
1. Remove the existing auxiliary port terminal from the vehicle.
2. Install the revised auxiliary port, wire harness, and noise filter.
Tape the noise filter to the back side of the trim panel near the auxiliary port ensuring the filter does NOT touch other parts or the wiring harnesses in the vehicle.
A. Connect the vehicle wire connector (4P) into the filter, and connect the filter wire connector (8P) into the filter. Figure 3.
B. Secure the filter to the vehicle wire harness using wire ties.
C. Install the NEW auxiliary port to the console box.
D. Connect the filter wire connector (8P) into the NEW auxiliary port.
3. Reassemble the vehicle in reverse order of disassembly.
4. Verify proper operation and that NO noise persists in the auxiliary mode of the audio system.

APPLICABLE WARRANTY
• This repair is covered under the Toyota Comprehensive Warranty. This warranty is in effect for 36 months or 36,000 miles, whichever occurs first, from the vehicle’s in-service date.
• Warranty application is limited to correction of a problem based upon a customer’s specific complaint.

TSB SUPERSESSION NOTICE
The information contained in this TSB supersedes TSB No. AU004-07.
• Applicability has been updated to include 2008 model year 4Runner, Prius, RAV4, and Solara.
• Parts Information has been updated to include a clarifying illustration. TSB No. AU004-07 is Obsolete and any printed versions should be discarded. Be sure to review the entire content of this service bulletin before proceeding.

Download Toyota Prius Noise Auxiliary Port External Device PDF Manual