Toyota Fuel System – Carburetor PDF Inspection Procedure Manual Guide

This system of fuel supply Toyota – Inspection procedure carburetor ebook will guide you to delete, assembly and distribution of Toyota carburetor assembly, the first page you will see the carburetor exploded views. Carburetor removal procedure: (a) Disconnect the hose air intake. (b) Remove the wing nut. (e) Disconnect the emission control of air pipes cleaner. (d) Remove the bolt assembly and VSV. (e) Lift the air filter on the carburetor. Remove the carburetor (a) Disconnect the fuel hose from the union. (b) Disconnect the emission control of pipes. (c) Disconnect the connectors. (d) Remove the four nuts and carburetor. Remove carburetor and a thermal insulator gasket.

Dis-assembly of carburetor: The following instructions are organized so that you work on one element of the group at a time. This will avoid the confusion of searching for items from different sub-assemblies being on your workstation at the same time. (a) To facilitate reassembly, organize parties in order. (b) Be careful not to mix the clips or the loss or springs. (e) the use of carburetor pilot set SST. Remove air support, remove the position of a fuel cut solenoid Remove (a) Remove the two clamps. (b) Disconnect the gas valve and the thread of the position of the clamp. (c) Remove the valve and a gasket. Remove the nipple union gaskets. Remove compensation. Remove the three screws, the position of a wire fixation, clearing and a seal.

HINT: Remove the compensation only if it is necessary to replace him. Remove the adjustment pin suction chamber. Remove the suction chamber and piston. Remove the pump arm. Remove float bowl: (a) Disconnect the cable from heating fuel to the clip. (b) Remove the five screws, union nipple clamp, butterfly solenoid, wire fixation, washer, registration plate, EGR vacuum modulator and the floating bowl. (c) Remove the pump sinking spring float bowl.

Clean disassembled parts before inspection: (a) using a soft brush, wash and clean the castings in the carburetor clean. (b) of the Clean carbon around the gas valve. (e) Wash the other parts thoroughly in clean fuels. (d) Blow dirt and other foreign matter jets, fuel passages and restrictions in the body.

INSPECTION OF FUEL FOR HEATING AND MIXING COLD HEATING (CMH) (a) Using an ohmmeter, measure the resistance between the terminals of the float bowl. Fuel heating resistance 20 ° C (68 ° F): 2 – 6 If the resistance is not correct, replace the float bowl.

Download Toyota Fuel System – Carburetor PDF Inspection Procedure Manual Guide

 

Filed Under (Toyota) by m4d35 on 11-07-2009
Related Automotive:

• Ford Demon1998 PDF Instruction Installation Manual
• Honda TRX 450 Duals PDF Installation Instruction
• Ford SuperCrew PDF Installation Manual
• BMW K1200 RS Z4020 Titanium Exhaust Z-Chip Z4025 PDF Installation Manual
• Toyota GT28R Hybrid Stock Twin Turbos PDF Installation Manual