Toyota Camry Multi Media Navigation System PDF Installation Manual

1 – Make sure you have the tools you will need

These common items are needed to complete this installation: · Digital multi-meter (DMM) · #2 Phillips screwdriver · Panel removing tools
·1/4” drive sockets are often needed for dashboard and trim disassembly
·Torx or Allen-drive wrenches if they are used on any panels you will be removing · for testing the system A DVD or CD in good condition

Standard installation parts you may need include wire, wire ties, wire crimp connectors or solder, electrical insulating tape, and foam tape. Installation of aftermarket automotive electronics also often requires access to special parts. It is a good idea to have a source for these common installation parts.

2 – Inspect the vehicle and plan your work

CHECK THE BATTERY Test the battery voltage to make sure it’s fully charged and inspect battery terminals for tightness and any corrosion. This only takes seconds and can save hours of troubleshooting later.

3 – Turn the Vehicle OFF or Disconnect the Battery

Be sure to turn the vehicle OFF before starting, and keep the vehicle OFF until the installation is fully completed BEFORE the vehicle is turned on.

Note
Failure to follow these instructions may cause the AIRBAG FAULT SENSOR to become enabled. Fault Sensors which have been enabled will require the Dealer Service Department to reset them. Dealerships often
charge a significant fee to reset the Fault Sensor.

4 – Remove the Interior Trim Components

You will need to remove the interior trim components prior to removing the factory radio. The following steps will help guide you through this process.

Note: When removing the Interior Trim Components, use caution to prevent damage to the components. If you are unsure about the removal process, consult the OEM Service Manual for additional instructions.

Note: Once the Interior Trim Components have been removed, be sure to inspect the clips for any damage. Damaged part must be replaced before re-installation.

5 – Remove the Factory Radio

You will need to remove the Factory Radio and prepare the Rosen Multi-Media unit for installation. The following steps
will help guide you through this process.

Note: Be sure to inspect all brackets and clips to ensure they were not damaged during the removal process. If any brackets or clips were damaged, replace them prior to installation of the Rosen unit.

Download Toyota Camry Multi Media Navigation System PDF Installation Manual