Toyota Avalon 2008 Interface Kit for iPod PDF Manual


caution is required when installing this accessory to the injury does not occur at the vehicle. installing this accessory to the approved guidelines to ensure quality installation. These instructions can be found in the “Accessory Installation Practices document.
This document covers such items as:
• Vehicle Protection (mittens and blankets, cleaning, etc.).
• Safety (eye protection Rechecking torque procedure, etc.).
• Vehicle Disassembly / Assembly (panel removal, part storage, etc.).
• electrical components Disassembly / Assembly (battery release connector removal, etc.). See your Toyota dealer for a copy of this document.

1 Remove the negative (-) cable battery
(a) Set parking brake.
(b) Remove the negative battery cable. (Fig. 1-1)
(1) Protect the fender before starting.
(2) Do not touch the positive terminal with any tool when removing cable.
2. Vehicle Disassembly
(a) Remove the front passenger side doorsill (Fig. 2-1)
(b) Remove cowl cover. (Fig. 2-2)
(1) Remove the plastic nut.
(2) Pull on the cover in the direction shown to remove.
(c) Remove the glove box (Fig. 2-3)
(1) Remove the plastic cover.
(2) Open the glove box.
(3) Remove the 4 screws and 1 bolt.
(4) Pull the glove box straight out to remove.
(d) Remove the dash and head unit.
(1) Remove the trim piece to the left of the steering wheel. (Fig 2-4)
(2) Remove the trim piece around the steering wheel. (Fig 2-5)
(3) Disconnect the connectors to the steering wheel trim piece.
(4) Remove the head unit trim piece (Fig. 2-6)
(5) Disconnect any connectors.
(6) Remove the head unit. (Fig. 2-7)
(7) Disconnect the head unit connectors. NOTE: During re-installation, bolts 1 and 2 should be secured first.
(e) Gently pull out the radio/HAVC cluster in order to access the plug-in location and rest on a support platform to prevent scratching of dash panels. (Fig. 2-8) NOTE: Be careful not to put too much tension on the radio wire harness when pulling out the radio.
3. Install and Route the Interface Unit.
(a) Locate the pipe shaped cross member.
(b) Place two (2) 14” lock ties around the cross member as shown. (Fig. 3-1) NOTE: Do not tighten the lock ties.

Download Toyota Avalon 2008 Interface Kit for iPod PDF Manual

 


Tagged Under : , , , , , , , Filed Under (Toyota) by m4d35 on 30-03-2010
Related Automotive:

No Comments «
»

Leave a Reply