Toyota Avalon 2000-2004 Part Number: TY-51-00 PDF Installation Instructions

STEP 1.
Begin by opening the arm rest cover. Insert your hook tool under the left side of the small trim piece next to the cup holder. Pull gently to release
the left retainer clip. Repeat on the right side to remove the trim piece. Remove the two (2) Phillips screws that are behind the small trim piece.
Next, set the emergency brake and put the gear shift lever into gear. Remove the trim bezel around the gear shift by inserting your hook tool
under its edge and gently pulling upwards. Work your hook tool around the bezel to release all six (6) clips. Lift the panel up and set aside. Do
not disconnect the wiring .

STEP 2.
Under the temperature control module is a small black panel that is held in place with two (2) clips. Remove the panel with your hook tool.
Remove the two (2) 10mm bolts that at the bottom of the temperature control module. Note: Use extra care when completing the next step.
The louvers in the air vent fall out of the vent very easily. Insert your hook tool in the air vent above the radio to release three (3) retainer
clips. (See 2nd photo). Slide the vent out of its cavity and disconnect the emergency flasher wiring. Set the vent aside. Remove the two (2)
10mm bolts above the radio. Slide the radio-temperature control module out of its cavity and set to the side. Do not disconnect the wiring.

STEP 3.
Place the Pro.Fit VSM® mount to the right of the radio, against the dash pad. Align the top of the custom mount to just below the radio centering
hole. (See 3rd photo). Using the custom mount as a guide, mark two (2) pilot holes. Using a 5/64” drill bit and drill carefully drill two (2) pilot
holes. Place the custom mount back into place, insert the two provided screws and tighten. Reassemble the dash in reverse order.

Download Toyota Avalon 2000-2004 Part Number: TY-51-00 PDF Installation Instructions