Remote Car Starter Model 40026 PDF Installation Manual

Feed the antenna around under the dash and up the inside of the right or left windshield post and over the top of the windshield. Clean the windshield with the rubbing alcohol pad, wait to dry. Remove the paper backing from the double sided tape to mount the last eight inches of the antenna behind the rear view mirror. The more exposed the antenna is, the better the range and performance.

Now plug the end of the antenna into the remote starter module. In some vehicles you will get better range performance if the antenna is pointing verti-cally downward from the top of the windshield. The wiring section of the installation is now complete. Be sure to cap all unused wires so as to prevent short circuits, and mount the module securely under the dash. When tying up and mounting the unit, be sure to avoid any moving parts (steering column, pedals) and sharp edges.

The remote starter contains a built in diagnostic routine that will indicate why the unit started or why the unit turned off the car the last time that the unit was used. To activate the diagnostic mode for why it turned off, simply turn the On/Off control switch to the “OFF” position, the LED will turn Green.
In a few seconds, the Green LED on the switch will flash 1 to 12 times to identify the problem. See the chart below for an explanation of the flashes:

If you want the factory setting, DO NOTHING and skip this section. If you want to change one or more of the features, then continue with the following procedures:
1. Open the hood.
2. Press and HOLD the brake pedal.
3. Quickly press and release the programming button once.
4. Release the brake pedal.

The control LED will flash Red 1 time1 (signaling that you are now in the Option Programming mode). The LED color reflects the first option (Green LED is for Factory set-ting, Red LED is for Optional setting). Pressing the brake pedal advances to the next option. By continuing to push the brake pedal, the user will advance through all of the options and then start back at Option #1 again.
After pushing the brake pedal, the LED flashes Red (the # of the option) before turning Red or Green, reflecting the state of the option (Green for factory setting, Red for Optional setting). If no options are selected or changed after 6 seconds the unit will automatically exit programming. Push the control switch so the LED is Red, the unit is now ready.

Download Remote Car Starter Model 40026 PDF Installation Manual

• Remote Car Starter Model 40026 PDF Installation Manual
• Remote Control Auto Alarm System PDF Installation Instruction Manual
• Universal Steering Wheel Control Interface PDF Installation Instructions
• Honda Acura iPod LockPick PDF Installation And Operational Manual
• Audi Q5 Homelink System Operating Instructions and Programming PDF Guidelines