R1200 C Motorcycles Clock And Tachometer Mount Bracket Installation PDF Manual

Read these instructions carefully and thoroughly before beginning work. Before installing the accessory, carefully consider whether one possesses the necessary technical skills (you must know how to access the battery on your R1200C)and workshop tools to complete the installation properly. Otherwise, any BMWMotorcycle Retailer will be glad to install this accessory.

Retain all fasteners removed from the motorcycle. All but a few fasteners will be reused. Placing removed fasteners into separate bags will be helpful in reassembly.

PRE-ASSEMBLE GAUGES
1. Insert the Wire Harness into the Gauge Bracket from below the gauge cups. The harness end with the lamp goes to the left, the harness end with five wires goes to the right.
2. Place a gauge sleeve on the clock side (leside) of the gauge bracket.
3. Connect the clock wires and light from the harness to the back of the clock. slide the clock into the gauge sleeve. Be certain your clock is aligned for correct reading after light bulb and wires are hooked up.
4. Use the nylon female screws to secure the gauge. (Hex Key Wrench 4mm) Tighten the female screws securely. Be careful, over tightening will strip the female screws.
5. Assemble the Rev Counter into sleeve and bracket and connect the wires to the wire harness by color.

Download R1200 C Motorcycles Clock And Tachometer Mount Bracket Installation PDF Manual