Pontiac Vibe 2003-2008 Multi Vehicle Mount PDF Installation Manual

TOOLS NEEDED FOR DASH PANEL DISASSEMBLY
Dash Trim Tool (Part #SIT-104)
# 2 Phillips Screwdriver
9/32” Open End Wrench (for swivel)
Marking Pen

TOOLS NEEDED FOR MVM MODIFICATION (if required)
4 inch Mounted Bench Vise
12 oz. Ball Pein Hammer
Standard Tin Snips
Small File

Start by using a Dash Trim tool (part #SIT-104) in the lower right corner and release two (2) clips on the right side. Work your way to the left and
release two (2) clips on the left side. Lift from the bottom and tilt the bezel up. Push down on the top of the bezel to release the two (2) clips on the top. Remove the one (1) phillips screw in the location as shown in the picture to the left. Skip to Step 6 on the following page if you have not yet formed the bracket to fit your vehicle.

Place the MVM over the existing hole in the dash. Replace the phillips screw. Tighten down the MVM Carefully reinstall the dash in reverse order securing all screws and clips to the bezel. Install the included Ultra Slim Swivel #PHS-203 to your Multi Vehicle Mount or any other AMPs compatible device. Your installation is complete Before you begin to form your MVM, please make sure it looks exactly the way it does in the top picture. To begin, use a marking pen to draw the lines on the MVM as depicted in red in the middle picture to the left.

Note: See the red lines in the middle picture for guidance. Use a tin snips to cut along these lines. When the cuts have been made completely, continue by bending along the yellow line as depicted in the middle picture. Make this a 90° angle bend. If the bracket gets bent use a small hammer to pound out any imperfections. If the paint chips use some black paint to cover up the paint. Now go back to Step 4 on the previous page to finish installation.

Download Pontiac Vibe 2003-2008 Multi Vehicle Mount PDF Installation Manual