Peugeot Citroen Suzuki Grand Vitara Fiat Drive Wire Cruise Control Car Spesific PDF Installation Manual

1. Safety and General installation AP800 Interface
NOTE!: Before installation AP800 interface read also AP800 Cruise Control kit installation manual
Warning! Improper cable connection may result in short circuits, which can cause:
• Cable Fires
• Damage to electronic control equipment
• Failure of electrical functions
• Failure of engine
The securest form of connection is by soldering the cables and then insulation the connection. Because of the risk of short circuits, always disconnect the negative pole of the battery before starting installation.

Caution!
On disconnecting the negative pole of the battery, all the volatile memories of the convenience electronics will lose their stored data. The following equipment may have to be reprogrammed
• Radio code
• Clock
• Board Computer
• Seat position
• Timer
Caution!
To check the voltage in electric cables, use only a diode test lamp, voltmeter or scope. Test lamps, which light up, take too much current and the vehicle electronics may be damaged

Electronic interface module AP800:
The electronic module should always be mounted in the passenger compartment of the car, near the accelerator pedal with the 4mm sheet metal screws. Avoid places with excessive heat, dampness and high-tension leads. The most common mounting locations are under the dashboard on the driver’s side, behind the glove compartment or the drivers- or passenger-side kick panels. Do not mount the electronic module in the engine compartment. For mounting, mark holes, center punch and drill the 3mm holes or use the double-sided pad to stick the electronic module to a flat surface. Always check the other side for clearance before drilling. Temporarily install the electronic module in the selected position. DO NOT firmly screw the electronic module down unless you have easy access to the electronic module. Once the installation has been finished, the electronic module can be screwed down in the selected position.

Kit contents:
• T-harness
• Black-red power wire
Connect the Black-Red wire to a constant 12V power supply (insert 2A fuse in fuse holder)

Disconnect car battery
• Connect the black-red wire to constant +12V (30)
• Insert 2A fuse in fuse holder
• Disconnect connector A (4-pole) from potentiometer (fig.1).
• Solder the green wire on wire position 2 from the connector
• potentiometer (fig.2) Solder the gray wire add wire position 4 from the connector
• potentiometer (fig.2) Cut the wire from position 3 of the potentiometer connector. Solder
• the yellow on wire position 3 at the connector side. Solder the brown wire on position 3 at the main harness side (fig.3) Cut the wire from position 1 of the potentiometer connector. Solder
• the white wire on position 1 at the connector side. Solder the pink wire on position 1 at the main harness side (fig.4)

Download Peugeot Citroen Suzuki Grand Vitara Fiat Drive Wire Cruise Control Car Spesific PDF Installation Manual