Mitsubishi Lancer Evolution 2008-2009 Dynojet CMD-1112 PDF Installation Manual

TOOLS REQUIRED
• 10mm socket with ratchet • 12mm socket with ratchet • zip tie cutters • mini flat blade screwdriver

INSTALLATION
1 Using a 12mm socket with ratchet, loosen the nut on the main power distribution block and remove the main power cable. Live power. Dynojet recommends covering the end of the cable with electrical tape to avoid shorting the main power lead.
2 Remove the red and black engine cover.

3 Locate the boost control solenoid connector. The boost control solenoid connector is located near the main power distribution and the air box as shown in Figure A and D.
4 Unplug the boost connector from the boost solenoid.
5 Attach the male boost connector from the CMD harness to the female OEM connector.
6 Attach the female boost connector from the CMD harness to the OEM solenoid.

7 Locate the MAF sensor connector. The MAF sensor connector is located near the main power distribution and the air box as shown in Figure A and F. 8 Unplug the MAF connector from the MAF sensor. 9 Attach the male MAF connector from the CM harness to the female OEM connector. Note: Verify the connectors are secured properly by giving the wires a light tug.

10 Attach the female MAF connector from the CMD harness to the OEM sensor located on the factory air box. 11 Locate the 10mm bolt on top of the PCM cradle. 12 Secure the CMD ground wire to this bolt. 13 Route the CMD harness under the boost and bypass hoses to the top of the engine near the coils. Zip ties are provided for a clean installation. Make sure to leave enough room for engine movement. 14 Locate and disconnect the injector connectors.

Download Mitsubishi Lancer Evolution 2008-2009 Dynojet CMD-1112 PDF Installation Manual