Mini Cooper Alarm Sound System PDF Installation Instructions Manual

These instructions were developed specifically for MINI vehicles and are not to be compared to any existing instructions for vehicles other than MINI. No methods other than those specified in this document are to be used to install the MINI Hands-Free Phone System with Bluetooth™ Wireless Technology in MINI vehicles.

Part Description
Wiper Stalk with status light
Alarm Siren with Tilt Sensor
Bracket Alternate Power Siren
Ultrasonic Module
Hex Bolt with Washer (M6x12 Z1)
Hex Nut with Plate (M6)

INSTALLATION PROCEDURE:
1. Disconnect Battery prior to starting the installation.
2. Remove the cover (1) for the Ultrasonic Module located above rear seat.
3. Place the Ultrasonic Module (5) into the cover (6) making certain that the arrows on the module and the cover are aligned.
• Clip the module into the cover.
4. Connect the module (5) to connector X1582.
• Reinstall the cover.
5. Attach the Power Siren (1) to the mounting bracket (2) using an M6 nut (3).
6. The black 4-pin connector X19562 (1) located in the left rear corner of the engine compartment near the ABS/ASC Hydraulic module is taped to
the wiring harness.
• Carefully remove the tape that secures the connector to the harness (1).
7. Connect the black 6 pin connector (2) to the siren (1).
8. Remove the plastic film covering the mounting hole for the siren bracket (1).
9. Secure the mounting bracket and siren (1) into place using a hexagonal screw M6x12 (10) and Hexagonal nut (13).
10. Remove lower section of steering column trim:
• Remove ignition switch rubber (1)
• Remove screws (2)
11. Remove knee bolster (1) by carefully pulling the plastic cover forward.
12. Remove lower trim cover:
• Release lower trim cover (1) retaining clips (4).
• Remove lower trim cover by pressing in on the upper trim cover (arrow).
13. Remove upper section of steering column trim:
• Remove two screws (1) at rear of gauges.
• Disconnect plug.
• Remove remote gauge cluster.
• Remove upper trim cover.
14. Remove the wiper switch:
• Remove screw (1).
• Remove the wiper switch (arrow).
• Disconnect connector (2).
15. Install the new wiper switch (1) with anti-theft status indicator.
Note: The removed wiper switch should be returned to the customer when the vehicle is picked up.
16. Reinstall all removed components and trim covers.
17. Reconnect Battery.