Mazda 6 2006-2008 Installation Instructions For Part 99-7507 PDF Manual

Due to differences in factory tolerances you may need to apply the provided felt tape to the edge of the 99-7507 radio housing to relieve backlight bleed through. 1. Looking at edge of radio housing apply felt tape to inner edge (toward back of kit). If it is positioned to closely to the outer edge you may be able to see it once it is in the dash.

1. Press and hold the AMB button on the factory display for 5 seconds then release the button. The first character will be highlighted. Settings will begin with the first character location. Use the AMB button to select the desired character then wait. The next character will be highlighted. Press and release to set that character,and keep going until the text is to your liking. There are 10 available character locations.

2. Once the desired text is entered press and hold the AMB button for greater than 5 seconds then release and the display will read “Text Saved.” Locate the factory wiring harness in the dash. Metra recommends using the proper mating adapter and making connections as shown. (Isolate and individually tape off the ends of any unused wires to prevent electrical short circuit.)

Re-connect the negative battery terminal and test the unit for proper operation. Reassemble radio and dash assemblies in reverse order of
disassembly.

Download Mazda 6 2006-2008 Installation Instructions For Part 99-7507 PDF Manual