Lexus Multi Vehicle Mount Gear Shifter PDF Manual

Insert the Dash Trim Tool in the lower left corner of the gear shifter bezel and carefully pry upward to release the first clip. Work the rest of the bezel loose with the trim tool releasing the remianing three (3) clips. Set the bezel aside Skip to Step 5 on the following page if you have not yet formed the bracket to fit your vehicle.

Locate the upper right clip hole to the right of the gear shifter. Locate a flat area just below the clip hole. Place the mount on this flat spot and use a marking pen to mark a spot to drill a pilot hole, using the hole in the mount as a guide. When the pilot hole is drilled place the mount over the hole aligning the hole in the mount with the pilot hole. Insert the provided screw and tighten down the mount with the Phillips screwdriver.

Carefully reinstall the dash in reverse order securing all screws and clips to the bezel. Install the included Ultra Slim Swivel #PHS-203 to your
Multi Vehicle Mount or any other AMPs compatible device. Begin forming the Multi Vehicle Mount by cutting the Multi Vehicle Mount
along the solid red line with a tin snips. See picture #1. Smooth out with file if necessary. Note: You do not want any sharp edges

At this point, your Multi Vehicle Mount should look like the image in picture #2. Bend the bracket at a near 90 degree angle so that it is flat
along the backside. Note: It is easiest to bend the bracket with a small bench vise and the use of a small hammer to flatten to perfection.After step six, your bracket should look like picture #3 below. When it is bent at a near 90 degree angle, smooth out the edges so there are no sharp points. Use a crackle coated paint if you have damaged any exposed areas. Now go back to step 4 on the previous page to continue your installation…

Download Lexus Multi Vehicle Mount Gear Shifter PDF Manual