Kia Sorento CRDI XE & XS Alarm System Part Number 01959G316K PDF Installation Instructions

When making the connections as detailed above, the Sorento RHD Wiring Diagram Manual (Pt No A3EE-EG 20A) must be available to confirm that the correct Connector, Pin Number and wire colour is identified before connection takes place.

All connections (ex earth) from the alarm harness must be spliced and soldered Into the vehicle harness as shown below Tools to use are shown opposite and include: wire cutter & end stripper, wire stripper, soldering gun, self fluxing solder And amalgam tape. Identify the correct wire on the Vehicle loom to be spliced into and strip Back 8 to 10mm of insulation using the Wire strippers. Identify the wire from the alarm harness that will be spliced into the vehicle harness and strip back the insulation 15mm using the wire cutter/end strippers. Wind the end of the alarm harness wire around the un-insulated part of the vehicle wire 2 to 3 times until it is firmly fixed. At this point give the alarm wire a slight pull to ensure that it will stay in position during the soldering operation.

An electric or gas fired soldering gun can be used for the soldering operation. When the gun is up to the correct temperature, place the tip on the underside of the joint to be soldered. Apply the solder on the OPPOSITE side Of the gun. The solder will begin to melt and flow into the joint towards the other side. As the temperature increases, the solder will Completely melt and flow easily through the joint giving a shiny appearance. At this point, remove the gun and allow the joint to cool. Inspect all around the joint to ensure that the solder has flowed through the joint. Firmly pull on the alarm wire to confir the joint is fixed. Insulate the joint using amalgam tape If you are unsure of how to solder or out of practice, then please practice soldering techniques before you fit this alarm system. Note: 95% of alarm failures are caused by poor installation, most of which are attributed to poor wiring connections.

Installation Note: Prior to commencing the installation of the alarm system, ensure that the contents are complete and that you are fully conversant with the splicing and soldering technique shown on the previous pages. If you require additional information or experience difficulty during the alarm installation, PIN CODE entry or set up procedures, then please contact the Cobra Vehicle Security Help Line.

Firstly, tear off the top part of the identification label which details the PIN Code and serial number. Secondly, stick the top part of the identification label over the bottom part as shown. Thirdly, enter the PIN Code in the box provided within the the Customer User Instructions.
Do this now as you will need the code when programming the system after installation. Note; Failure to record the PIN Code correctly as described above, will prevent the user from accessing certain features of the system. Fit the multi pin harness connecter into the siren block and ensure it is fully home. The antenna wire must be positioned as shown.

This will ensure it is not trapped when the connector cover is fitted. Fix the plastic connector cover onto the back of the siren using the four 10mm long self tapping screws provided. Ensure that the antenna wire is not trapped and exits the cover in the correct position. Remove the three M6 nuts securing the cooling system header tank. Lift the tank and position to one side as shown allowing access to the N/S bulk head area. Locate the M6 stud located on the bulkhead and secure the siren bracket using the M6 flange headed nut provided. Secure the siren in position onto the bracket using the two M6 sq headed bolts and M6 nyloc nuts.

Download Kia Sorento CRDI XE & XS Alarm System Part Number 01959G316K PDF Installation Instructions