Kia Sorento 2003 – 2007 Bracketron Part Number KIA-200-03 PDF Installation Instructions

Tools Needed: Dash Trim Tool, (Part #SIT-104), #2 Phillips Screwdriver, 5/16” open-ended wrench. Parts Included: Custom Bezel Mount (Part “A” and “B”), Two (2) cap nuts, and instructions.. Location of Mount: To the right of the climate control.

Step 1: Begin by opening the ashtray door. You will need this door to be open when releasing the bottom clips. With the Dash Trim Tool, release the air vent bezel to the right side of the radio and climate control. Start at the top and work your way down to the bottom of this bezel. There are six (6) clips that secure this bezel (Three on the top section and three on the bottom section). Set trim bezel aside.

Step 2: Locate and remove two Phillips screws that secure the right side of the climate control unit. Set screws aside. Place the smaller part “A” over these two screw holes as shown in middle picture. Insert original factory screws and tighten.

Step 3: Replace the trim bezel by securing six clips. Start at the bottom and work your way up to the top securing each clip. When bezel is secure, attach the larger part “B” to the smaller part “A” by inserting the threaded studs through the small holes on part “A”. For the Kia Sorento, use the top hole and bottom hole nearest the passenger. Use a 5/16” open-ended wrench and tighten the two provided cap nuts to secure part “A” and “B.”

Step4: Install any Bracketron phone holder or Amps compatible device to your Custom Bezel Mount. Your installation is complete.

Download Kia Sorento 2003 – 2007 Bracketron Part Number KIA-200-03 PDF Installation Instructions

• Hummer H2 2005-2007 Part CHE-304-01 PDF Installation Instructions
• Buick Lucerne 2006-2007 Bracketron Phone Mount PDF Installation Manual
• Lexus LX 470 Toyota Land Cruiser Part Number LEX-202-03 PDF Installation Instructions
• Toyota Avalon 2000-2004 Part Number: TY-51-00 PDF Installation Instructions
• Pontiac Vibe 2003-2008 Multi Vehicle Mount PDF Installation Manual