Jet Trax Motorcycle PDF Instruction Manual

Instructions on this site are provided for informational purposes only ar ‘, that is used for custom installation and operation. Current guidelines are provided eacn witn Manufacturer units. Manufacturer’s instructions for installation and operation should be carefully followed. STEP 1 – Read the instructions before starting the installation, paying special attention to all safety notes.

STEP 2 – Universal Mounting Plate is a flat panel that measures 1 / 2 “x 3″ x 48 “. Place the mounting plate to the bed to pick up 1 / 2″ to 1 “in front of the bed and the middle left to right.

Instructions for installation and operation of the department ToyTrax
A. The half ton Ford beds, remove existing transportation screws and attach mounting plate with a new 5 “long bolts, nuts and washers provided.
B. On all other vehicles, locate crosspiece Bedframe the truck. Then choose two mounting plate pre-drilled holes and drill two 9 / 16 “holes into the bed and Bedframe for attachment.”) O does not use two threaded holes for mounting to the bed bar for trucks. If bedliner and bed mat is in place, cut-out around the mounting plate before installation so that the mounting plate rests flat metal bed of the car.
NOTE: On some trucks, where Bedframe is located on the front side of the bed, you must connect the mounting plate installation druhé 1 / 2 “x 3″ x 17 “flat panel under bed. Drill two 9 / 16″ diameter holes in bottom truck, as well as the bottom 17 “flat panel for the match with holes to 7″ apart in the top 48 “mounting bar. then connects via screws, Locknuts and washers.

STEP 3 – Add 5 “to attach the mounting plate with screws, bedliner, truck and Bedframe and tighten securely using nuts and washers provided. (Use the shorter 3″ screws, if you are using flat steel under a truck) Be careful not to overtighten. Overtightening could cause damage to the truck bed. Next, pull the troops ToyTrax to bed and set the front 3 “channel ToyTrax to lie on the mounting plate. Align the holes in 2 slot ToyTrax with 2 threaded holes in the mounting plate and fasten loosely with two 1 / 2″ x 2 1 / 2 “bolts, 1 / 2 “lock washers and 1 / 2″ flat washers provided. center front channel to the mounting plate and tighten the two screws securely

Download Jet Trax Motorcycle PDF Instruction Manual