Jeep Wrangler (TJ) 2003–2006 AMP Installation PDF Guide Manual

Installing rivet nuts
1) Assemble rivet nut installation tool, as shown in Figure 1
2) Place of assembly in the hole in the fabric so that the rivet nut is seated flush with frame
3) Use the key to hold the rivet nut install tool and tighten the bolts (see fig.2)
4) Make sure the nut flush rivet rest while tightening bolt.
5) Tighten bolts to 30 lb-ft (41N-m)

Make sure the screws sit flush rivets when completely installed Installation liaison with M8 x 35 bolts and washers M8. Do not torque bolts, tighten finger Installation media for the conduct of assembly and fastening nut on the top rear.

NOTE: Right and left conduct meetings. FRONT hook attaches to side gear.

Download Jeep Wrangler (TJ) 2003–2006 AMP Installation PDF Guide Manual