Hummer H3 3.5L/3.7L/Chevrolet Colorado/GMC Canyon PowerAid Throttle Body Spacer PDF Installation Instruction

Parts List
(1) Power Plate
(1) “O” Ring
(4) 6mm x 60mm Bolts
(4) 6mm Flat Washers
(2) Extension Plates
(2) 6mm x 20mm Flat Head Screws

Tools List
5/16” Socket (Hose clamps)
10mm Socket
4mm Socket (stud removal)
Ratchet & Extension
4mm Allen Wrench

Installation Instructions.
1. DISCONNECT NEGATIVE (-) BATTERY CABLE.
2. Loosen the hose clamp and remove the intake hose on the left front corner of the resonator box. Remove 2 bolts on the passenger side of the resonator. (Ref. “D”)
3. Loosen the hose clamp on the throttle body and carefully work loose, lift the resonator and rotate it to the left. * Use caution to remove the breather hose connected to the valve cover.
4. Remove the air intake system and throttle body. (Ref. B) Remove 4 studs from intake manifold.
5. Install power plate with the o-ring side of plate facing the throttle body, use supplied (4) 6mm x 60mm bolts and flat washers. (Ref A & C)
6. * 2.8L, & 2.9L engine- Install (2) extension plates using (2) 6mm x 20mm flat head screws. (Ref. D)
* Please Note- Extension plates are not necessary for 3.5L, 3.7L, or 4.3L engines.
7. Inspect & Test throttle linkage for full Open & Closed travel before driving. Some cruise or kickdown cables may require adjustment. Please refer to the vehicles service manual for proper adjustment.
8. Reinstall the air intake system using (Steps 2&3) as an example. Make sure to reconnect the crankcase breather hose!
9. Reconnect negative battery cable. Enjoy!
Included with your Poweraid Spacer is a sticker with a California Air Resources Board (C.A.R.B.) Executive Order (EO) number. This sticker must be placed in plain view inside of the engine compartment. Failure to do so may prevent you from passing a smog inspection.

Download Hummer H3 3.5L/3.7L/Chevrolet Colorado/GMC Canyon PowerAid Throttle Body Spacer PDF Installation Instruction