Honda Civic 2006 SI Supercharger Kit PDF Installation Instruction

Thank you for purchasing the CT Engineering Supercharger kit for the 2006 Honda Civic SI. All components have been designed and manufactured utilizing the latest in technology and materials. Please take a moment to read this instruction manual and warranty information page thoroughly before starting any work. Always work in a clean environment and use the appropriate safety equipment and tools to avoid any potential damage or injuries. CT Engineering recommends the use of a Genuine Honda Service Manual to supplement these instructions.

All CT Engineering products are intended to be installed by a professional installer. Many stock parts are reused during installation. Do not damage or discard any pieces during disassembly or installation. We recommend marking any hose or wire before disconnecting to avoid confusion during reassembly.

Remove the cover (A) off the fuel rail connection. Disconnect the fuel line from the rail by squeezing the lock tabs, push and pull the line until it is loose. Remove the two M8 nuts holding the rail to the manifold and remove the rail with injectors. Keep the two rail spacers and the rail; they will
be reused. Remove the hardware holding the throttle body to the manifold. Remove the throttle body from the intake manifold, all parts will be reused.

From the bottom of the car disconnect the connector from the brace (A). Remove the hardware holding the support to the manifold/block and remove the brace (B). They will not be reused. Remove the (2) M8 nuts and (6) M8 flange bolts. Using the two M8 Nuts as Jam Nuts, remove the two studs from the cylinder head. Remove the intake manifold and disconnect the water line as you remove the manifold. Neither manifold, gasket or hardware will be reused. Remove the MAP sensor (A), screw and o-ring from the stock manifold; they will be reused. Remove the Intake Air Bypass Thermal Valve (B) from the stock manifold; it will be reused in the new Supercharger manifold. Make sure to also remove the throttle body studs, they will be installed in the supercharger inlet manifold.

Release the auto-tensioner (A) with a Snap-on tool (YA9317) or similar tool. Once the pressure is releasedremove the belt; it will not be reused. Remove the A/C support bracket bolt. It will not be reused. Remove the (2) M8x45 bolts holding the idler pulley assemble. The hardware will be reused but the bracket and pulley will not.

Download Honda Civic 2006 SI Supercharger Kit PDF Installation Instruction