Honda Civic 2 and 4-Door 2009 Aluminum Wheel P/N 08W17-SNA-101A PDF Installation Instructions

This aluminum wheel is designed for use on the TPMS (Tire Pressure Monitoring System) vehicle.
• This aluminum wheel is equipped with the TPMS sensor. See the Service Manual for tire replacement procedure and TPMS sensor installation procedure (paragraph of Tire Pressure Sensor Replacement).
• The illustration of the aluminum wheels are shown for reference purposes only.
• Install the correct size tire.
• Use a tire changer to remove and install the tires. Using a tire lever to remove and install the tires can damage to the tire, the wheel, and the TPMS sensor.
• The wheel nut torque is 108 N·m (80 lbf-ft)
• The standard wheel nuts may not be used with the aluminum wheels. Replace them with the correct wheel nuts which are sold separately as described.

1. Clean the mating surface and the valve hole of the aluminum wheel.
2. Install the tire pressure sensor and the washer to the aluminum wheel, and loosely install the valve nut. Make sure the pressure sensor is resting on the wheel. NOTE: Install the tire pressure sensor so that the sensor housing surface should not exceed the wheel protrusion to prevent the sensor housing caught to the bead of the tire when assembled the tire.
3. Tighten the valve nut to the specified torque while holding the tire pressure sensor toward the wheel. Tightening torque: 4 N·m (0.4 kgf·m, 3 lbf·ft) NOTE:
• Do not reuse the grommet that had been tightened, even one time, to the specified torque, as they are deformed inside.
• Do not use pneumatic or electric tools on the valve nut.
• Tightening the nut to the specified torque or above can damage the grommet.
4. Install the tires according to the instructions in the Service Manual.
5. Install the wheels on the vehicle and torque to 108 N·m (80 lbf-ft).

Models equipped with standard 17” wheels. Tire pressure caution label and Supplemental Information are not used. Perform steps 6 and 7 for models not equipped with standard 17” wheels.
6. Open the driver’s door. Using isopropyl alcohol, clean the area where the accessory tire pressure caution label will attach. Remove the backing from the label and attach it over the existing tire information label. Attach the tire pressure caution label or label C or label D according to the following information:
Label: For EX-L Model with a T125/70D15 95M
Label C: For EX-L Model with a T135/80R16 101M
Label D: For EX-L Model with a T135/80D16 101M

7. Attach the “Supplemental Information” page included in this kit to the Owner’s Manual. For the method of attaching the page, refer to “To the
dealer:” attached to the “Supplemental Information” page.

Download Honda Civic 2 and 4-Door 2009 Aluminum Wheel P/N 08W17-SNA-101A PDF Installation Instructions