GM / Cadillac / Hummer NV_RGB_X OEM Navigation Dual Video Input Interface Module With Wiring Harness PDF Installation Instruction

Table Of Contents:
Section
Pre-Installation Disclaimer
RGB Module Connections & Controls
Source DIP Switch Settings
Installation With Plug And Play Factory Harness
Installation With Universal Harness
Installation For GM / Cadillac / Hummer
General Installation
NAV VIDEO RGB 16pin Molex Connection Diagram

Pre-Installation Disclaimer:
By purchasing and installing our products, you agree that NAV VIDEO Inc., its employees and affiliates cannot be held responsible for any accidents, tickets, misuse of products or damage caused to your vehicle. The driver must always keep their eyes and attention on the road at all times. Our products are intended for passenger entertainment and off-road use. In some states it is illegal to have a TV viewable by the driver
while the vehicle is in motion, please obey your state laws. In addition it is your responsibility to provide this disclaimer to any party that may purchase your NAV VIDEO navigation interface from you, in or out of your vehicle. NAV VIDEO cannot be held responsible for discrepancies, or inconsistencies that may occur due to vehicle manufacturing changes. Please adhere to all state and federal laws when operating your video
interface.

RGB Module Connections & Controls
The NV_RGB_X Video Interface is capable of both single video and dual video modes of operation. For dual video mode, the optional remote control pad is recommended for switching between the video inputs on the module. The NV_RGB_X Video Interface has a number of connections and controls on the module, they are outlined below….

Composite Video Input For Backup Video Camera (or any other video device)
Composite Video Input For Any Video Device
Brightness POT Control
Color POT Control
Contrast POT Control
Tint Pot Control
Five dip switches used to configure the sync setting of the module which varies from vehicle to vehicle, a complete list of sync settings can be found in the next section of this installation guide.
This is where the wiring harness provided with the module will be connected. In addition the wiring harness has several important wires which are outlined below:
• (RED) 12V (accessory position) switched power
• (BLACK) Chassis Ground
• (BLUE) Parking Brake or Ground
• (GRAY) Reverse Light or 12V Signal To Activate Video1 Input For Camera
The black wire that is labeled “Add A Switch To Ground” is intended to be connected to a momentary switch (not included). The other connector on the switch will be attached to ground. When the module senses a ground connection, it will switch to the next video input. Going from the OEM Nav Screen -> Video 1 -> Video 2 and back.

Installation With Plug And Play Factory Harness
If your RGB unit came with an OEM fit factory harness, simply find the GPS navigation computer (either in the trunk, under a seat, or behind the LCD head unit) and remove the existing factory connector attached to it. Plug the new RGB wiring harness in, then connect the vehicle connector to the other end of the new RGB wiring harness. Each vehicle manufacturer varies, but in general here are the locations we recommend for each respective manufacturer:

Download GM / Cadillac / Hummer NV_RGB_X OEM Navigation Dual Video Input Interface Module With Wiring Harness PDF Installation Instruction