Ford Focus ZX3 2000-2003 Short Ram PDF Installation Manual

AEM Short Ram air intake system is the result of extensive development in a wide range of cars. It is the most advanced short pipe air intake system on the market. Each system is specially designed for the particular application. All AEM Short Ram Air intake systems provide maximum performance by increasing the light, all-aluminum, rack-Bent tubing, which is tuned to both the length and diameter. Aluminum does not continue to crack use, such as plastic.

The tube length and diameter of the value of each individual engine to power a broad range of RPM. Unlike plastic systems, which use a variety of continuous cross-section, we make use of acoustic energy inlet duct to promote cylinder filling during the intake valve-opening event. Each intake is coated with a glossy, heat-reducing Zirconia based powder coating.

This special blend of powder coating helps to reduce heat penetration, which in turn reduces the temperature of the intake charge. Cooler intake air temperature is more power from burning because the cool air is denser than warm air. Mass air flow to the engine is increased, because increased air flow and reduce the initial temperature, which means more power. Read and understand these instructions before attempting to install this product.

1) Setting Up
a) Make sure the vehicle is parked on a flat surface.
b) Set the parking brake.
c) Disconnect the negative battery terminal.
d) If the engine is to run the last two hours, let it cool.

2) removal of stock air intake system
a) Loosen the hose clamps to draw first position is a gas intake pipe of the body and the primary position of manifold air mass sensor.
i) Remove the primary stock intake pipe.
b) Disconnect the wiring harness from the mass air sensor.
c) Remove the stock intake pipe sensor with the included Torx ™ tool and the book, because it uses the AEM intake install. Be careful not to damage the mass air sensor.
d) Remove the valve cover vent hose air cleaner housing.
e) Remove the air cleaner housing from the vehicle. This is done by pulling straight up on the housing market. Is not bolt to housing in
f) Remove the two plastic keep downs the second intake pipe.
g) Remove the secondary supply pipe of the engine by increasing the Mount straight up.
h) Remove the secondary supply tube through the front of the vehicle.
i) Remove the air cleaner housing at the top of the Assembly.
j) Stock Remove the lower air cleaner air filter housing Assembly

Download Ford Focus ZX3 2000-2003 Short Ram PDF Installation Manual