Ducati ST4s PDF Installation Manual

Locate the vacuum – There is a gap in the entry point of the tracks, as shown below left. Remove the screws and replace it with the M5 brass valve on the Scottoiler kit, using a little RTV silicone sealant on the son to ensure a perfect seal. Then press on the shutter Elbow, number 4 on the tap.

The RMV can be mounted on the chassis, as indicated by the arrows in the third image. The more vertical the RMV the better and remember to avoid exhaust and engine components. For other mounting options, see our installation guide easy step “RMV Positions, General.”

The distributor of the Assembly, shown bottom left, is routed along the underside of the swingarm using Dispenser Mounting Sleeve, Cable Ties & Glue. Note: an epoxy resin (eg Araldite) is req’d to bond the sleeves to the swingarm. For more information, please see our installation guide easy step – Provide general meetings.

Once installed, the complete and the first system and adjust the potentiometer setting of “premium”. Start the engine and turn the tuning knob until a flow rate of 1 to 2 drops per minute is reached. Check the condition of your chain after a turn, and then adjust as needed. The feather should feed the sprocket between the 6 and 7 hours, positions, with the side cut to the outside. The Dual Injector (sold separately) is shown below.

Download Ducati ST4s PDF Installation Manual