Ducati Nemesis Engine Control PDF Manual

Destiny uses both of the original multi-pin connectors to link with your bike wiring loom, no changes are necessary, but remember that it is very important to restore the link between 6mm connection to the earth. Nemesis was also re-uses the cast aluminum “heat” of the AIF 5.9 ECU, which can be removed and re-equipped with a Nemesis TORX T20 screwdriver without causing damage to the Original ECU.

IMPORTANT – Make sure the back (opposite mating), the cast aluminum “heat sink” is free from corrosion to ensure a good electrical connection between the rear panel of Nemesis and the “heat sink . NEVER fit any stickers or any other object on the rear panel of Nemesis that could restrict the trajectory. Secure Nemesis using the M6 screws and nuts.

Wiring options:
Nemesis All kits come with a cable, as shown here, it plugs directly into the Nemesis using the connector from the slot between the 2 main connectors bike. Route the 3-way PC communication gray connector to any suitable place, which gives you access to this jack when the ECU is replaced cover panel and the assembly is again mounted on the bike.

You May Also Bought Loom development which has the same connector to connect to Nemesis, but the following additional entries. 4-way AMP connector with yellow tape to connect to a broadband sensor lambda.

Download Ducati Nemesis Engine Control PDF Manual