Ducati Hypermotard PDF Installation Manual

1) It is essential to use Blue Loc-tite on all bolts and nuts. Remove any other direction stabilizers.
2) It is a good idea to cover the tank with an old sweat-shirt, towel or protective device in order not to scratch it.
3) The aluminum parts are color photos to help show the contrast of assembly. Production parts are anodized black.
4) Remove the (4) Allen bolts that hold the handlebars tight. Carefully lay your bars before the frame, wrapping the bars and levers of a towel or adequate protection, you have to turn the front end of the next operation.

5) The holding of the head in place with Allen key, remove the 15mm nut on the bottom of the triple clamp to hold the bar tight fitting. Remove the lower stock mounts. Washing machines, which sit under the bottom of the perch between the bushings and the stock perches, should go to the playground area at the bottom of the new mount SUB us (see photo).
6) Install the new Under-mount-bottom using perch stock Allen tighten bolts and nuts of 15mm with the stock washers.
7) Do not set the bar yet. Follow the thread of the key and unplug the switch from safety, it is taken on the left side.

Remove the (2) Acorn nuts that hold the plastic lid and return it upside down. You’ll find the “ring of security that immobilizes your bike to prevent theft. There are (2) small tabs that hold the security in place. To remove the ring of security, you must raise a little on each side back until it comes out. Fold carefully tab back slightly and lift the ring to clear the first tab lip. Then the other tab, a small amount at a time. Do not leave the ‘ring! Some rings are lightly glued in place, but they come with a gentle persuasion. If you come from the other side with a stick of ice or other persuasion grows, you can help make the Security ring passed through the mouth of the tabs.

9) Install the safety ring in the new plastic cover that we have provided. You can see the relief of the area of the sensor to adapt. The ring of security itself needs to be seated flush the water in the recreation area in the black cap, he can not touch any metal.
10) the wire feed through the aluminum frame and support the snap in the plastic lid provided recreation. This is a press release form, but it is better to use a little blue loc-tite on the press fit area to help keep this place. Plug the cable back in. If the plastic is not top center itself or maintenance flush, look inside to make sure the “gray” tabs do not prevent its installation.

11) The new ticket cover is the anchor point for the stabilizer, it should sit around the flushing whole basis of the key to provide the necessary support. We found the stock of bicycles varies key casting, refusing to cover our flushing and in rare cases, when you tighten the bolts, it’s bow tie and housing around the pin. Try the new key to cover the first and try to ensure that it is flush with the base area. If there is a casting “couture”, you can touch, lightly sand off until the cover is flush. The best, it takes the more functional, it will be. If the turn of the pin does not float, then try again.

Download Ducati Hypermotard PDF Installation Manual