Dodge 2005-Present Charger Grill Set PDF Installation Guide

Figure 1 Examples of low-profile Philips screwdriver. 1) Ratchet (¼ “drive) with ¼” jack and Philips bit. 2) Offset Philips screwdriver.
1.1) Remove radiator covers. First, immerse the hood of the vehicle. There are two plastic protective shields the radiator area. These are held in place by small clips that you go simply by pulling on the pieces. Fig. 2 shows these covers and shows their removal.
1.2) Remove the frame grille screws. The grid consists of two parts, the frame grille and the grille (Fig. 3). Both must be from the vehicle, the radiator grille with a low-profile Philips screwdriver (Fig. 1) to remove the four screws that secure the assembly to the bumper grille. The location of these screws are shown in Fig. 4
1.4) Remove the grille assembly of the bumper. After the four screws are out of the grille assembly, the frame grille is still held in place by four tabs on its perimeter. These tabs are made from the engine compartment (Fig. 5). Insert a slot screwdriver between the frame grille and the bumper on the outside of the vehicle (Fig. 6). And gently PRY the grille under the bumper by freeing any of the four tabs, like your work around the frame grille.
1.5) Remove the grill from the grille frame. First free the outer sides of the grille from the frame by using a slot screwdriver between the grill and the frame on the clip tab (Fig. 7.1), and PRY upward until the slot grill is free from the lips to hold tab on the frame (Fig. 7.2).

Download Dodge 2005-Present Charger Grill Set PDF Installation Guide