Chevrolet S10 1998-2000 Blazer Sportsman Assemblies PDF Installation Instructions

Replace the side of the Spacer Tube, Top Mounting Bracket, Flat Washer 10mm, 10mm Lock Washer, and M10-1, 5 x 50mm Hex Head Bolt. (See note below). At Chevrolet models except ZR2, the short end of the summit, the mortgage holder to go down, and the Chevrolet S-2, GMC and Oldsmobile models of the short end of the summit Mount Bracket up to be.

Remove the grille of the car. At a Chevy Blazer and S10 models, the mask is considered (9) nine video clips, metal grille and turn signals. It is the GMC Sonoma and Jimmy and Oldsmobile Bravada, trellis is maintained (7) seven metal clips, and a center grille has been removed. By removing the grille and the car, pull firmly until the clips to the network of metal release. The work of the passenger’s side, go to the middle and finally the driver’s side.

Clear the box and check for possible damage. Check all parts against the parts list. Read and understand instructions completely before beginning installation. Remove the 10mm bolts on the bumper bracket located behind the front of the facility to install, if available. On both sides, the place of the body behind the mounting bracket to install and safe to use my existing 10mm bolts removed in step 3 (Vehicles, there are no bolts, using a 10mm bolt HARDWARE KIT).

And adjust the level of the athlete of the vehicle and torque than the 10mm fasteners (Mount to frame locations only) 35 Ft. Lbs. Remove the athlete of the vehicle opposite to Step 8 Replace the grille in the reverse order of removal and re-connect wiring connectors and lamp housings if necessary. Re attach the athlete of the vehicle and tighten the fasteners: 1 / 2 “thread 60 Ft. Lbs. Top Brackets to install, remove, (2) two 10mm factory bumper bolts from the top frame, the rear bumper to the top.

Download Chevrolet S10 1998-2000 Blazer Sportsman Assemblies PDF Installation Instructions