Chevrolet Colorado 2004-2009 GMC Canyon ReadyLift PDF Installation Instructions

Position truck on a flat surface and lift vehicle by the frame for the front wheels are off the ground. Use minimum 3 ton jack and is held as part of security or a two (2) if it has elevators. Make sure the emergency brake and the rear wheels are locked to prevent deployment. Remove the front wheels. Disengage ABS line in the upper control arm.

Remove the 13mm retaining nut ABS line support. Remove the 21mm nut tie rod end. Separate tight end from the knuckle of the address. Remove the 15mm sway bar end nut upper link. Besides end link sway bar. Remove the 21mm lower shock mounting nut and bolt. Remove the four ball nut and bolts upper joint. Use a 12mm in the 13mm bolt and the nut. Remove the three upper strut mounting nuts, bolts and remove the lower mounting bracket. Remove the lower ball joint nut and screw the domain locatedbehind bar end links. Install the lower shock mount Steel Beam offered in this package.

Install the extension plates under shock, M14 bolt, two washers M14 and M14 c-.. locking nut ears sure soldiers face to face. Do not tighten. Install the M12 bolt, two washers, and C-nut. Do not tighten. Reinstall the strut and the top three nuts, but not tight. Install the supplied M14 bolt, washers and lock nuts c-. Tighten to factory

Download Chevrolet Colorado 2004-2009 GMC Canyon ReadyLift PDF Installation Instructions