Free Download Automotive PDF Manual

Tools required:
• Flat Screwdriver
• 10mm Deep Socket
• ¼” Drive Socket

1. Start by unplugging the MAF sensor by using a screw driver to remove the clip as shown.
2. Push fitting in and pull up to remove the wire harness from the MAF sensor.
3. Remove the bolts that hold the stock air box in place as shown and set aside for reuse with the MAC system.  Read more...

Position truck on a flat surface and lift vehicle by the frame so that the front wheels are off the ground using a floor jack and jack stands or a (2) two post lift if available. First, remove driver side front wheel, then unbolt upper shock mounting nut.(A) Next remove lower shock mounting nut and bolt.(B) Remove shock. Install shock stem spacer provided and reinstall bushings and shock.(C) & (D) Verify that all fasteners have been tightened to the proper torque specs and reinstall wheel. *Be sure to torque the lug nuts to the proper OEM settings.  Read more...

TOOLS NEEDED
Floor Jack X 1
Jack Stands X 2
Puller Tool X 1
Hand Tools
18mm socket and wrench

BILL OF MATERIALS
P11321 RT X 1 Torsion Key
P11322 LT X 1 Torsion Key
P11405 X 1 Instructions  Read more...

Tools Required
Safety glasses
Metric wrench set
1/4” drill bit
1/4”, 3/8”, & 1/2” drive metric socket set (standard and deep)
8mm hex (Allen) wrench
3/8” and 1/2” drive, foot pound and inch pound torque wrenches
Belt tensioner wrench or 1/2” breaker bar
7/32” socket
Drill and 5/16” drill bit
Phillips and flat head screwdrivers
Fuel quick disconnect tools (included in kit)
E5 internal Torx socket
Small or angled 3/8” drill motor
Drain pan
Compressed air  Read more...

Use your 10-mm socket and ratchet to remove two (2) washer nuts from the inside of the small cubby hole under the radio and airbag switch. Set the washers aside. Remove two (2) 10-mm screws from the bezel below the steering column. Set the screws aside. Pull the bezel toward you releasing six (6) clips. On the passengers side, remove two (2) 10-mm screws on the lower bezel below the glove box. Set the screws aside. Pull toward you to release two (2) clips and a pin that is connected to the larger radio bezel.  Read more...

TOOLS NEEDED:
2.5mm allen wrench
10mm socket
13mm socket
10mm wrench
extension
flat blade screwdriver
ratchet
t-20 torx wrench
Drill motor
1/2” Drill Bit  Read more...

TOOLS NEEDED:
Ratchet
Extension
8MM Socket
10mm Socket
10mm Wrench
7/16” Wrench
9/64” Allen Wrench
Flat Blade Screwdriver

….  Read more...

Step 1: Applies to H3 ONLY, for Colorado/Canyon please skip to step 2.
Position truck on a flat surface and lift vehicle by the frame so that the front wheels are off the ground using a floor jack and jack stands or a (2) two post lift if available. First, remove driver’s side front wheel, then unbolt upper shock mounting nut. (A) Next remove lower shock mounting nut and bolt. (B) Remove shock.  Read more...