C-Series Racks Assembly PDF Instructions Guide

Install the front line.
The front bar is a smooth rectangle around the tube with the bolt holes in each end. Secure the front line to ‘H brackets “are mounted on the front rail sections with (4) 3 / 8″ -16 x 2 “carriage bolts (4), 3 / 8″ split lock washers and (4) 3 / 8 “-16 nuts. Finger tighten only.

Connect the front and rear
Note the different orientation of the screws on the rail transport group.
To round top tube, use (2) 3 / 8 “-16 x 1-3/4″ carriage bolts (2) 3 / 8 “split lock washers and (2) 3 / 8″ – 16 nuts, installation hardware finger tight. Repeat on the other side of the railway.
For the lower rectangle tube use (4), 3 / 8 “-16 x 3″ carriage bolts (4), 3 / 8 “split lock washers and (4), 3 / 8″ – 16 nuts, installation hardware finger tight. Repeat on the other side of the railway.

Connect the front and rear
Each side rail includes a front side and rear of preassembled for easier installation. Front and rear associated. Remove bandage and separate front and rear rail sections from the packaging. On a flat surface, place plate at the front and rear rail sections, as indicated, the rear “bracket Y ‘does not affect the country. This will allow the reconciliation front and rear rail sections faster. On the front (end with a straight round tube), slide the 5 “bracket back until two holes on the back 5 ‘bracket with two holes at the bottom end of the pipe rectangle. Insert the rear of the rails and 5 “bracket and line up the remaining two holes.

Download C-Series Racks Assembly PDF Instructions Guide