Audi S4 1999 – 2002 ST-22 Rear 328mm Big Brake Upgrade PDF Installation Manual

Some models, even years, the use of vehicles of different size fasteners in May. Every effort has been taken to identify the correct size tool for every job. Sometimes, the manufacturer in May to use a different attachment. Make sure each tool is the correct setting before loosening or tightening it. Tools and equipment are required: 14mm key (in some cases, 9 / 16 “May be required), 11mm key (in addition, a key 11mm torch is also recommended), 10mm socket or key, 10mm Allen (hex) wrench, 8mm Allen (hex) wrench, Vise-grip pliers or, Needle-nose pliers or small flat blade screwdriver, Torque wrenches capable of 10-85 lb-ft parameters, Small tray or several rags.

Small funnel or the means of filling the master cylinder brake bleed bottle 1 pair of jack stands or other means of vehicle support 3 or DOT 4 brake fluid. Consult the manufacturer’s recommendations for compatibility. StopTech recommends flushing brake fluid every 1-2 years or more often in severe conditions. If not done recently, installing a brake kit is an excellent opportunity to refresh your brake fluid, or upgrade to a better performance of the fluids, such as Motul 600.

Step 1
Raise the vehicle and remove wheels
Note: All photographs show left side installation, unless otherwise indicated. Some images of the manual in May not to be out of the vehicle, but they give a good representation of the installation. StopTech recommends working on one side of the vehicle at the time, so that the reference may be made on the other hand, if uncertainty arises during installation.

Caution: Never leave a vehicle supported only by a jack. Always use jack-stands. A stable and clean surface, to support the vehicle is taken, must be used for installation. For a rear installation kit, block the front wheels, and release the parking brake, then falling on the rear wheel nuts, the two front wheels of the car jacking.

Refer to the owner’s manual to determine the correct location of the jack to lift the vehicle. Jack the vehicle and set on a pair of jack stands, referring to the owner’s manual for the location of the joints.
After obtaining the vehicle at a height, remove the front wheels. To facilitate access to the line of fittings brake, turn the steering either into or out of the party that you work, depending on the orientation of the stapes.
If you install a bracket, turn the steering to the side as you work, and if you install a mobile bracket, turn the steering away from the party that you work. It will be easier to access the caliper bolts.

Download Audi S4 1999 – 2002 ST-22 Rear 328mm Big Brake Upgrade PDF Installation Manual