Audi A6 Single-Frame Front Bumper Installation PDF Manual

Placement of the Hofele Design front bumper on the car: Place the new bumper on the car, but no nut. Preparation of the bonnet: Remove the front grill and the rubber band behind him. Install the front grill (HF-7052-S4 / RS4) in the tunnel. Placement of the tunnel: Place the tunnel on the bonnet / hood and fix it with tape. Adjustment of the front grill so there is still a gap between the bumper and grill.

Removal of the original bumper: Remove any screws that hold the bumper. Also remove the screws that holds the alloy bar and remove the bumper with the alloy bar. Remove the alloy bar of the bumper and install the new bumper Hofele-Design.

Screws of the bumper: After the proper alignment of the bumper and front grill, you can screw the bumper. Therefore, drilling two holes with a diameter of 10mm in the bumper and 8mm diameter in the alloy bar. Then cut a M8 thread in the holes. Use the supplied screws + washers to screw the bumper. Adhesives of the tunnel and the bonnet / hood: Mark the position of the tunnel with tape. Sand the surface to clean and beyond. Then, the special glue (a part of delivery) to the tunnel. Place the tunnel on the bonnet / hood and fix it with tape until the glue is dry (at least 24 hours)

Download Audi A6 Single-Frame Front Bumper Installation PDF Manual