1993 Suzuki Swift Adjustments PDF Manual Guide


One of my favorite car is from Suzuki – so I post the PDF Manual Guide from them first. See the summary contents of PDF document below:

* Remove valve cover. Rotate engine until zero degree (TDC) timing mark of timing belt cover is in line with timing mark on crankshaft pulley. See Fig. 1. ** Ensure cylinder No. 1 is at TDC on compression stroke. Remove distributor cap. On Samurai and Sidekick (TBI), ensure rotor is pointed upward at distributor hold-down bolt and to No. 1 terminal of distributor cap. On Sidekick (MPI), ensure rotor is at about 1 o’clock position and pointed to No. 1 terminal of distributor cap. If rotor is not as described, rotate crankshaft 360 degrees. *** Measure valve clearance between adjustment screw and valve stem using shim thickness gauge. Check intake valve clearance of cylinders No. 1 and 2 and exhaust valve clearance of cylinders No. 1and 3. See VALVE CLEARANCE SPECIFICATIONS table. **** Turn crankshaft one complete revolution (360 degrees). Check intake valve clearance of cylinders No. 3 and 4 and exhaust valve clearance of cylinders No. 2 and 4. ***** Adjust valves by loosening lock nut and turning adjusting screw until clearance is as specified. After adjusting clearance, tighten adjusting screw lock nut to 11.0-13.5 ft. lbs. (15-18 N.m) for Samurai or 90-108 INCH lbs. (10-13 N.m) on Sidekick. On all models, recheck clearance.

If you interest with this PDF Manual, you can Download it – 1993 Suzuki Swift Adjustments PDF Manual.

 


Filed Under (Suzuki) by m4d35 on 26-12-2008
Related Automotive:

No Comments
»

Leave a Reply